www.radartutorial.eu www.radartutorial.eu Radar Basics

Range or distance measurement

Radar principle:
An electromagnetic pulse travels at the speed of light from an antenna to an airborne target. There the energy is reflected and the echo signal moves back at the same speed and is received by the antenna. The time measurement (in the picture symbolized with stop watches) permits to calculate the distance of airborne target from the run time and the known speed.

Figure 1: Runtime measurement by radar

transmitted energie
echo signal

Figure 1: Runtime measurement by radar

Hintergrundbild transparente Animation:
Ein elektromagnetischer Impuls bewegt sich (mit Lichtgeschwindigkeit) von einer Antenne bis zu einem Flugziel. Dort wird die Energie reflektiert und das Echo bewegt sich mit gleicher Geschwindigkeit zurück und wird von der Antenne empfangen. Auf einem Oszilloskop läuft zeitgleich ein Leuchtfleck mit. Zum Zeitpunkt des Empfangs des Echosignales wird dort ein Echoimpuls geschrieben. Der Abstand dieses Echoimpulses zum Sendeimpuls ist proportional zur Zielentfernung.

Figure 1: Runtime measurement by radar

Range or distance measurement

The radar transmits a short radio pulse with very high pulse power. This pulse is focused in one direction only by the directivity of the antenna, and propagates in this given direction with the speed of light.

If in this direction is an obstacle, for example an airplane, then a part of the energy of the pulse is scattered in all directions. A very small portion is also reflected back to the radar. The radar antenna receives this energy and the radar evaluates the contained information.

The distance we can measure with a simple oscilloscope. On the oscilloscope moves synchronously with the transmitted pulse a luminous point and leaves a trail. The deflection starts with the transmitter pulse. The luminescent spot moves to scale on the oscilloscope with the radio wave. At this moment, in which the antenna receives the echo pulse, this pulse is also shown on the oscilloscope. The distance between the two shown pulses on the oscilloscope is a measure of the distance of the aircraft.

Since the propagation of radio waves happens at constant speed (the speed of light  c0) this distance is determined from the runtime of the high-frequency transmitted signal. The actual range of a target from the radar is known as slant range. Slant range is the line of sight distance between the radar and the object illuminated. While ground range is the horizontal distance between the emitter and its target and its calculation requires knowledge of the target’s elevation. Since the waves travel to a target and back, the round trip time is dividing by two in order to obtain the time the wave took to reach the target. Therefore the following formula arises for the slant range:


  • c0 = speed of light = 3·108 m/s
  • t = measured runtime [s]
  • R = slant range antenna - aim [m]

The distances are expressed in kilometers or nautical miles (1 NM = 1.852 km).

Derivation of the equation

Range is the distance from the radar site to the target measured along the line of sight.

Equation 2: speed (v) as a function of time (t) and range (s)


Formel 3: wie die Formel 2, aber die Strecke (s) wurde durch die zweifache Entfernung (2·R) ersetzt. Die Geschwindigkeit (v) ist also nun dargestellt durch den Quotienten aus der zweifachen Entfernung (2R) geteilt durch die gemessene Zeit (t). Die Maßeinheit ist immer noch Meter pro Sekunde.


The factor of two in the equation comes from the observation that the radar pulse must travel to the target and back before detection, or twice the range.

Formel 4 = Formel 1: Die Formel drei wurde umgestellt: die Entfernung (R) ist nun die Hälfte des Produktes aus der Lichtgeschwindigkeit (C0) und der gemessenen Zeit (t). Die Maßeinheit ist Meter.


Where c0= 3·108 m/s, is the speed of light at which all electromagnetic waves propagate.

If the respective running time t is known, then the distance R between a target and the radar set can be calculated by using this equation.